i have a Titan ridge card, that sorta works, but more problems. yeh it works no problem, never tried asus card, cause i need two ports. I have same board, and gigabyte alpine ridge v 1.0 card. No errors no disconnections no problems under stress. I connected usb3.1 gen2 peripherals on the two thunderbolt ports and they work perfectly at the same time at 10GB / s Test thundebolt pass but I have no peripherals to test the card does not damage the asus integrated nic.ĭrivers thunderbolt correct install and usb controller asmedia correct install the titan does not damage the operation of the other cards that I have mounted. The card titan does not create irq problems, the card does not move the sequences of the other cards. Installa minumum drivers: intel_thunderbolt_.0 but i have install bb intel_thunderbolt_.0
Intel thunderbolt 3 firmware upgrade how to#
if you know how to set them write it down.Ħ) connect cable 5pin on titan and connect to asus.ħ) connect two pci power (the card works even without connecting the two pciex cables) But to obtain the full speed of this enclosure connected to the thunderbolt 3 I needed to have the last version of the TB3 Firmware installed (version 25). I was eager to test my External GPU (Mantiz venus + GTX 1050 Ti + SSD 250) enclosure through Thunderbolt 3. 1.0) requires the pci express 4.0 connectors "so it doesn't work on x299"Ġ) vga install on slot3 and titan install on slot2Ģ) select slot pciexpress = 2 " asus WS X299 SAGE/10G x299" support thundeborld only splot2ĥ) I don't know how to set the other parameters bios. I just acquired a new XPS 13 (9370) with 2 thunderbolt 3 ports pcie x4 and OPI GT4. The titan ridge card is the latest card that supports the x299 chip, the GC-MAPLE RIDGE model (rev. 2.0) and install this card on WS X299 SAGE/10G x299 So i changed the card with gigabytes GC-TITAN RIDGE (rev. When asus card is installed it creates problems for other cards including built-in 10g nic i can only use usb3 on the dedicated usb3 port. The thunderbolt port does not support usb 3. My motherboard: asus WS X299 SAGE/10G x299īecause Old firmware that cannot be updated.